|
|||||||
|
|||||||
|
|
|
|
|
|
||
 |
|||||||||||||||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|||||||||
 |
|||||||||||||||||||||
 |
|||||||||||||||||||||
SKINTOP® Strain Relief Cord Connectors |
|||
SKINTOP® Installation |
|||
1. Screw SKINTOP® into housing or tighten with locknut |
| 2. Put cable through* |
| 3. Tighten nut until rubber touches the cable completely |
| 4. PG 7 to PG 29 Tighten nut with ½ turn (180º) |
| 5. PG 36 to PG 48 Tighten nut with 1 turn (360 º) |
| *To avoid potential damage to the SKINTOP® internal ratchet design and vibration-resistant feature, it is not recommended to remove cap during installation. |
 |
© 2008 Lapp Group |
Lapp
USA or the Lapp Group are not affiliated with Lapp
Insulator. |
||||
